Owner manual
Brocade 7800 Extension Switch Hardware Reference Manual 29
53-1001350-04
Appendix
A
Product specifications
In this appendix
• “Brocade 7800 components,” next
• “Weight and physical dimensions” on page 30
• “Facility requirements” on page 30
• “Power supply specifications” on page 30
• “Environmental requirements” on page 31
• “Power cords (Japan, Denan)” on page 31
• “General specifications” on page 32
• “Data transmission ranges” on page 32
• “Memory specifications” on page 33
• “Fibre Channel port specifications” on page 34
• “GbE port specifications” on page 34
• “Serial port specifications” on page 34
• “POST and boot specifications” on page 35
• “Regulatory compliance” on page 35
Brocade 7800 components
The switch includes the following components:
• Cabinet-mountable 1U chassis designed to be mounted in a 19-in. cabinet space, with
forced-air cooling that flows from the nonport side of the Extension Switch to the port side.
• 16 Fibre Channel ports, compatible with short wavelength (SWL), long wavelength (LWL), and
extended long wavelength (ELWL) SFP transceivers.
• One Ethernet management port with 10/100/1000 Mbps autonegotiating capability
• Six optical/copper SFP GbE ports, compatible with short wavelength (SWL), long wavelength
(LWL), extended long wavelength (ELWL), or copper SFP transceivers
• Two fixed copper RJ-45 GbE ports.
• One IEEE-compliant RJ-45 serial cable, 10-ft (approximately 3 m) long. An RJ-45 to DB9
adaptor is also provided with the Extension Switch.
• One IEEE-compliant RJ-45 connector on the port side of the Extension Switch for use with a
serial console and 10/100 MBps Ethernet.
• Switch status and management LEDs: 1 power LED, 1 status LED, 2 Ethernet LEDs, 2 FRU
LEDs.