User Guide

Parameters
vrf vrf-name
Configures a static mroute for this virtual routing and forwarding (VRF) route.
ipv6-address-prefix/prefix-length
Configures the destination IPv6 address and prefix for which the route should be added.
ethernet
Configures an Ethernet interface as the route path.
ve
Configures a virtual interface as the route path.
cost
Configures a metric for comparing the route to other static routes in the IPv6 static route
table that have the same destination. The range is 1 to 16; the default is 1.
distance distance-value
Configures the route's administrative distance. The range is 1 to 255; the default is 1.
name name
Name for this static route.
Modes
VRF configuration mode
Usage Guidelines
The no form of this command deletes a previously configured static multicast route.
Connected routes on PIM enabled interfaces are automatically added to the mRTM table.
Examples
This example configures a static IPv6 mroute to directly connected network 2020::0/120 on virtual
interface ve 130.
Device(config-vrf)# ipv6 mroute 2020::0/120 ve 130
History
Release version Command history
8.0.10a This command was introduced.
ipv6 mroute (next hop)
Configures a static mroute with a next hop.
Syntax
ipv6 mroute [ vrf vrf-name ] ipv6-address-prefix/prefix-length next-hop address [ cost ] [ distance
distance-value ] [ name name ]
no ipv6 mroute [ vrf vrf-name ] ipv6-address-prefix/prefix-length next-hop address [ cost ] [ distance
distance-value ] [ name name ]
Command Default
No next-hop static mroute is configured.
Parameters
vrf vrf-name
ipv6 mroute (next hop)
216 FastIron Ethernet Switch IP Multicast Configuration Guide
53-1003085-02