Technical data

Fabric OS v6.1.0_del1 Release Notes, v1.0 Page 8 of 13
Documentation Updates
This section provides information on last-minute additions and corrections to the
documentation. The most recent Fabric OS v6.1.0 documentation manuals are available
on the Brocade Partner Network: http://partner.brocade.com/
Brocade Fabric OS Administrator’s Guide (Publication Number 53-1000598-03)
On page 349, replace the NOTE in the middle of the page with the following:
NOTE: For TI over FCR, all switches in the backbone fabric and in the edge fabrics must be
running Fabric OS v6.1.0 or later.
On page 351, in the section “Limitations of TI zones over FC routers,” add the following bulleted item:
• For TI over FCR, failover must be enabled in the TI zones in the edge fabrics. The failover
mode for TI zones in the backbone fabric can be enabled or disabled.
On page 359, in step 2b, replace the sample commands with the following:
E1switch:admin> zone --create -t ti TI_Zone1 -p "4,8; 4,5, 1,-1; 6,-1"
E1switch:admin> zone --show
Defined TI zone configuration:
TI Zone Name: TI_Zone1
Port List: 4,8; 4,5; 1,-1; 6,-1
Status: Activated Failover: Enabled
On page 360, in step 3b, replace the sample commands with the following:
E2switch:admin> zone --create -t ti TI_Zone1 -p "9,2; 9,3; 9,6; 1,-1;
4,-1"
E2switch:admin> zone --show
Defined TI zone configuration:
TI Zone Name: TI_Zone1
Port List: 9,2; 9,3; 9,6; 1,-1; 4,-1
Status: Activated Failover: Enabled
On page 361, in step 4a, replace the sample commands with the following:
BB_DCX_1:admin> zone --create -t ti TI_Zone1 -p "1,9; 1,1; 2,4; 2,7;
10:00:00:00:00:08:00:00; 10:00:00:00:00:02:00:00;
10:00:00:00:00:03:00:00"
BB_DCX_1:admin> zone --show
Defined TI zone configuration:
TI Zone Name: TI_Zone1
Port List: 1,9; 1,1; 2,4; 2,7; 10:00:00:00:00:08:00:00;
10:00:00:00:00:02:00:00; 10:00:00:00:00:03:00:00
Status: Activated Failover: Enabled
On page 365, in the section “Supported configurations for traffic prioritization,” change the bulleted item
“To be assigned high or low priority…” to the following:
- To be assigned high or low priority, hosts and targets must be connected to one of the
following:
• Brocade 300