Owner's manual

428 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Interface config commands
12
speed
Interface config commands
Specifies the speed of a fast-ethernet (10/100) or a gigabit-ethernet port (10/100/1000)
Displays current system information running on the controller.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
speed [10|100|1000|auto]
Parameters]
Usage Guidelines
Set the interface speed to auto to detect and use the fastest speed available. Speed detection is
based on connected network hardware.
Example
RFController(config-if)#speed auto
RFController(config-if)#
10 Forces 10 Mbps operation
100 Forces 100 Mbps operation
1000 Forces 1000 Mbps operation
auto Port automatically detects the speed it should run based on the
port at the other end of the link.Autonegotiation is a requirement
for using 1000BASE-T[3]
according to the standard.