Owner's manual

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 649
53-1001931-01
Wireless configuration commands
20
The following is the list of parameters for the radio <1-4096>, radio
[all-11a|all-11an|all-11b|all-11bg|all-11bgn|default-11a||default-11an|defau
lt-11b|default-11bg|default-11bgn]
commands.
admission-control voice
[max-clients <0-256>|
max-perc <0-100>|
max-roamed-clients
<0-256>|
res-roam-perc <0-100>]
Sets the admission control parameters for voice. The following
options are configured:
• max-clients <0-256> – Configure the maximum number of
clients to be admitted.
• max-perc <0-100> – Configure the maximum percentage of
air time allotted to voice traffic.
• max-roamed-clients <0-256> – Configure the maximum
number of roamed clients to be admitted.
• res-roam-perc <0-100> –Configure the maximum
percentage of air time exclusively allotted to clients that have
roamed. This value is calculated relative to the max-perc
value.
adoption-pref-id
<0-65535>
Employs a preference identifier for this radio port. The radio port is
more likely to be adopted by a wireless controller that is a
preferred controller.
adoption-policy [allow|deny] Specifies adoption policy. Select from :
• allow – Allows adoption
• deny – Denies adoption
ampdu [min-spacing
[.25|.5|0|1|2|4|8]|
rx-limit [16383|32767|
65535|8191]|
tx-limit <0-65535>|
tx-enable {min-spacing
[.25|.5|0|1|2|4|8]|
rx-limit [16383|32767|
65535|8191]|
tx-limit <0-65535>}
Specifies the settings for the MAC Protocol frames. The following
properties are configured:
• min-spacing [.25|.5|0|1|2|4|8] – The spacing between
MPDUs received in microseconds.
• rx-limit [8191|16283|32767|65535] – The receive buffer
limit in bytes.
• tx-limit <0-65535> – The transmit buffer limit in bytes.
• tx-enable {min-spacing [.25|.5|0|1|2|4|8]|rx-limit
[16383|32767|65535|8191]|tx-limit <0-65535>} –
Optional parameters for enabling transmitting A-MPDUs.
amsdu [rx-limit|
tx-enable]
Specifies the settings for the MAC Service frames. The following
properties are configured:
• rx-limit – The receive buffer limit in bytes
• tx-enable – Optional parameters for enabling transmitting
A-MSDUs
• <3839 bytes>|<7935 bytes> – The number of bytes
received
NOTE: Before executing this command, ensure the radio is
present and is a BR650 model.
antenna-mode
[diversity|mimo|primary|se
condary]
Defines the antenna diversity mode. Select from the following
options:
• diversity–Full diversity (both antennas)
• mimo – MIMO
• primary–Primary antenna only
• secondary–Secondary antenna only
NOTE: Before executing this command, ensure the radio is
present and is a BR300 model.