Vacuum Cleaner User Manual

18 Brocade SAN Switch Module: Installation Guide
4. Remove any SFP modules from the switch-module external Fibre Channel ports. For
SFP module removal instructions, see the documentation that comes with the SFP
module.
5. Pull the release latch toward the bottom of the switch module, as shown in Figure 7
.
The module moves out of the bay approximately 0.6 cm (0.25 inch).
Figure 7. Removing a switch module.
✏ NOTE
If you do not replace the switch module, you must insert a filler module into the
empty bay within 1 minute.
6. Slide the switch module out of the bay and set it aside. Within 1 minute, place either
another switch module or a filler module in the bay.
✏ NOTE
To make sure that the switch module is active after you replace it, see step 11 on
page 16 and step 12 on page 16.
7. If you placed another switch module into the bay and if you are using the external
switch-module ports, insert any SFP modules that you removed in step 4 on page 14
into external Fibre Channel port 0 and Fibre Channel port 15. For SFP module
installation instructions, see the documentation that comes with the SFP
module.
2
G
!
T
X
R
X
2
G
0
FC
FC
15
!
T
X
RX
O
K
OK
!
O
K
OK
!
1
2
3
4
L
I
N
K
NK
L
I
N
K
NK
T
X/
RX
L
I
N
K
NK
T
X/
R
X
L
I
N
K
NK
T
X/
R
X
T
X/
R
X
0
00
55
D8
D8
9A1
4
4
44
AC
D
C
2
G
!
T
X
RX
2
G
0
FC
FC
15
!
T
X
R
X
O
K
OK
!
O
K
OK
!
1
2
3
4
L
I
N
K
L
I
N
K
T
X/
X/
R
X
L
I
N
K
T
X/
X/
RX
L
I
N
K
NK
T
X
/
X/
RX
T
X
/
RX
0
00
55
D8
D8
9A1
4
4
44
AC
DC
Switch module
Release lever
Release-lever latch
SBCE unit