Vacuum Cleaner User Manual

26 Brocade SAN Switch Module: Installation Guide
Establishing a Telnet session through the management
module
Complete the following steps to establish a Telnet session through the Blade management
module:
1. In your browser, in the address bar, type http://xxx.xxx.xxx.xxx, where xxx.xxx.xxx.xxx is
the IP address of the SBCE management-module interface. Click GO or press Enter.
The Enter Network Password window opens.
✏ NOTE
The default IP address for the SBCE management module is 192.168.70.125.
Figure 10. Enter Network Password window.
2. In the User Name field, type the initial default user name, USERID. In the Password
field, type the initial default password, PASSW0RD (the sixth character is a zero, not
the letter O). The user name and password are case sensitive.
The Active Session from Same Client window opens.
Figure 11. Active Session from Same Client window. 3.In the Inactive session
timeout value field, select the timeout value for this Web session and click Start New
Session. The SBCE management-module main window opens.