Vacuum Cleaner User Manual

40 Brocade SAN Switch Module: Installation Guide
To activate and use these optional software features, you must purchase the corresponding
license keys. For information about these features, see the following documentation on the
Resource CD:
• Brocade Fabric OS Procedures Guide v4.2.0 or later
• Brocade Fabric OS Reference Manual
• Release Notes for Brocade Enterprise SAN Switch Module and Brocade Entry SAN
Switch Module
• Brocade Diagnostic and System Error Message Reference Manual
• Brocade Fabric OS Features Guide v4.2.0 or later
• Brocade Advanced Web Tools Administrator’s Guide v4.2.0 or later
• Brocade ISL Trunking User’s Guide
• Brocade Advanced Performance Monitor User’s Guide
See “Related documentation” on page 6 for descriptions of these documents.
The Enterprise version comes with a Full SAN Scaling (up to 239 switches) license. This
license allows for up to 239 domain attachments within a fabric. The Entry version is
limited to a two-domain fabric. The Entry version is upgradeable through the purchase of
an optional license key that provides Full SAN Scaling capabilities.
Before you can upgrade and install a new license key, you must determine the license
identifier (ID) of the switch module. Use the Telnet program to log in to the switch module
as described in Chapter 4, “Configuring the switch module through the Telnet interface,” on
page 25, and run the licenseidshow command to determine this value. Record the license
ID value future reference. For information about this command, see the Brocade Fabric OS
Reference Manual on the Resource CD.
To purchase and obtain a license key for an optional feature, go to contact your your Intel
support representative. A license key will be provided through the Web site that is described
in the documentation that you receive after you purchase the feature.
To install an optional feature on the switch, you must add the corresponding license to the
list of current features for the switch. Use the Telnet program to log in to the switch module
as described in Chapter 4, “Configuring the switch module through the Telnet interface,” on
page 25, and run the licenseadd "key" command, where key is the license key for the new
feature. For information about this command, see the Brocade Fabric OS Reference Manual
on the Resource CD.
To make sure that the license has been successfully added to the switch key, run the
licenseshow command. For information about this command, see the Brocade Fabric OS
Reference Manual on the Resource CD.