Technical data

ServerIron ADX Administration Guide 103
53-1002434-01
Setting passwords
2
NOTE
You cannot abbreviate this command. This command causes the device to ignore saved config.
5. Enter boot system flash primary at the prompt.
6. After the login prompt appears, use user name admin and password brocade to gain access to
the Exec Mode.
7. En te r enable to gain access to the privileged mode.
8. Copy the startup configuration into the running configuration, by copying the startup
configuration to a tftp-server and copying the same file from tftp to the running configuration.
9. Change the user password, and super-user password if necessary, and save the configuration.
Displaying the SNMP community string
If you want to display the SNMP community string, enter the following commands.
ServerIronADX(config)# enable password-display
ServerIronADX(config)# show snmp server
Contact:
Location:
Community(ro): .....
Traps
Cold start: Enable
Link up: Enable
Link down: Enable
Authentication: Enable
Locked address violation: Enable
Power supply state change: Enable
Fan failure: Enable
Redundant module state change: Enable
Temperature warning: Enable
STP new root: Enable
STP topology change: Enable
L4 maximum session limit: Enable
L4 TCP SYN limit: Enable
L4 server max connection: Enable
L4 server up: Enable
L4 server down: Enable
L4 server port up: Enable
L4 server port down: Enable
L4 switch standby: Enable
L4 switch active: Enable
HTTP match-list: Enable
The enable password-display command enables display of the community string, but only in the
output of the show snmp server command. Display of the string is still encrypted in the
startup-config file and running-config. Enter the command at the global CONFIG level of the CLI.