Technical data

ServerIron ADX Administration Guide 133
53-1002434-01
Configuring RADIUS security
2
Syntax: enable aaa console
DANGER
If you have previously configured the device to perform command authorization using a RADIUS
server, entering the enable aaa console command may prevent the execution of any subsequent
commands entered on the console.
NOTE
This happens because RADIUS command authorization requires a list of allowable commands from
the RADIUS server. This list is obtained during RADIUS authentication. For console sessions, RADIUS
authentication is performed only if you have configured Enable authentication and specified RADIUS
as the authentication method (for example, with the aaa authentication enable default radius
command). If RADIUS authentication is never performed, the list of allowable commands is never
obtained from the RADIUS server. Consequently, there would be no allowable commands on the
console.
Configuring RADIUS accounting
ServerIrons support RADIUS accounting for recording information about user activity and system
events. When you configure RADIUS accounting on a ServerIron, information is sent to a RADIUS
accounting server when specified events occur, such as when a user logs into the device or the
system is rebooted.
Configuring RADIUS accounting for Telnet or SSH (Shell) access
To send an Accounting Start packet to the RADIUS accounting server when an authenticated user
establishes a Telnet or SSH session on the ServerIron, and an Accounting Stop packet when the
user logs out.
ServerIronADX(config)# aaa accounting exec default start-stop radius
Syntax: aaa accounting exec default start-stop radius | tacacs+ | none
Configuring RADIUS accounting for CLI commands
You can configure RADIUS accounting for CLI commands by specifying a privilege level whose
commands require accounting. For example, to configure the ServerIron to perform RADIUS
accounting for the commands available at the Super User privilege level (that is; all commands on
the device), enter the following command.
ServerIronADX(config)# aaa accounting commands 0 default start-stop radius
An Accounting Start packet is sent to the RADIUS accounting server when a user enters a
command, and an Accounting Stop packet is sent when the service provided by the command is
completed.
NOTE
If authorization is enabled, and the command requires authorization, then authorization is
performed before accounting takes place. If authorization fails for the command, no accounting
takes place.