Technical data

2 ServerIron ADX Administration Guide
53-1002434-01
Setting up local user accounts
1
Displaying user information
To display user information, enter the following command.
ServerIronADX(config)# show users
Username Password Encrypt Priv Status
Expire Time
=============================================================================
======
admin $1$T62..hu1$hmRolcV1Vwc.FCtXVD6h9/ enabled 0 enabled
Never
Configuring Telnet
The ServerIronADX supports up to five concurrent inbound Telnet and SSH sessions, one outbound
Telnet session, and console access. Write access through Telnet and SSH is limited to one session
only.
To access the CLI shell running Switch (S) code, Telnet or SSH to the assigned management IP
address, assuming your client is on the same subnet of course.
If you are on a different subnet and running Switch code, configure an ip default-gateway
<ip-addr>. This command also assists SNMP management.
If you are running Router (R) code, the management ip address must be set on a reachable system
interface (physical or virtual). Use ip route 0.0.0.0 0.0.0.0 [<next-hop-ip>] to install a static route in
R code.
Use show who or show telnet to display both Telnet and SSH user session information.
ServerIronADX(config)# ip address 10.1.1.1 255.255.255.0
ServerIronADX(config)#show ip
Switch IP address: 10.1.1.1
Subnet mask: 255.255.255.0
Default router address: 10.1.1.2
Default IP MTU (Bytes): 1500
TFTP server address: None
Configuration filename: None
Image filename: None