Technical data
14 ServerIron ADX Administration Guide
53-1002434-01
Managing System Functions
1
Syntax: reload [after <dd:hh:mm>] | [at <hh:mm:ss> <mm-dd-yy>] | [cancel] [primary |
secondary]
The after <dd:hh:mm> parameter reloads after the specified amount of time has passed.
The at <hh:mm:ss> <mm-dd-yy> parameter reloads at exactly the specified time.
The cancel option negates the scheduled reload.
The primary | secondary option specifies whether the reload is to occur from the primary code
flash module or the secondary code flash module. The default is primary.
The reload command must be typed in its entirety.
Logging into a BP
To log into a Barrel Processor (BP) on the Application Switching Module card, enter the following
rconsole command.
NOTE
A BP is the Applications traffic switching processor.
The example moves the CLI session from the management processor (MP) to BP 1 on the
Application Switching Module in slot 1. Notice the end of the command prompt changes to indicate
the ASM slot number and BP number.
Syntax: rconsole <asm-slot-number> <bp-number>
The <asm-slot-number> variable specifies the chassis slot containing the module (see show
module).
The chassis slots specified in the <asm-slot-number> variable are numbered 1 - 2 from top to
bottom in a ServerIron ADX 4000 chassis.
The chassis slots specified in the <asm-slot-number> variable are numbered 1 - 4 from top to
bottom in a ServerIron ADX 8000 chassis.
The slot specified in the <asm-slot-number> variable is always 1 in a ServerIron ADX 1000.
The <bp-number> parameter specifies the BP (numbered from 1 – 8 maximum).
Use the rconsole-exit command to return to the MP.
Timing out idle serial management sessions
You can time out idle serial management sessions. By default, a device does not time out serial
CLI sessions. A serial session remains open indefinitely until you close it.
ServerIronADX# rconsole 1 1
ServerIronADX1/1#
asm show all application switch module commands
rcon-exit Exit rconsole
rconsole-exit Exit rconsole
show Display system information
write Write running configuration to terminal
ServerIronADX1/1# rconsole-exit