Technical data

22 ServerIron ADX Administration Guide
53-1002434-01
Using the USB port and USB flash drive
1
The show ip mgmt-route command is shown in the following and the other commands are
described in the ServerIron ADX Switch and Router Guide.
Displaying management port route information
On switch code you can display management port route information as shown in the following.
ServerIronADX(config-if-mgmt-1)# show ip mgmt-route
Total number of IP routes: 1
Destination NetMask Gateway Port Cost Type
----------------------------------------------------------------------
1 10.10.10.0 255.255.255.0 0.0.0.0 mgmt1 1 D
2 192.0.0.0 255.0.0.0 10.10.10.254 mgmt1 1 S
Syntax: show ip mgmt-route
On router code, you display management port route information as shown in the following.
ServerIronADX# show ip route
Total number of IP routes: 2
Start index: 1 D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination NetMask Gateway Port Cost Type
----------------------------------------------------------------------
1 10.10.10.0 255.255.255.0 0.0.0.0 mgmt1 1 D(N)
2 192.0.0.0 255.255.255.0 10.10.10.254 mgmt1 1 S(N)
Syntax: show ip route
Using the USB port and USB flash drive
All ServerIron ADX models are equipped with an internal and an external USB port. The internal
(usb0) port is a USB drive with 4 GB of memory. The external (usb1) port points to a USB connector
on the ServerIron ADX switch where you can connect an external USB flash drive.
NOTE
The external USB port (usb1) does not support USB hard drives.
The following sections describe procedures for:
• Creating directories on USB drives.
• Removing directories on USB drives.
• Displaying contents of USB drive directories.
• Copying files between ServerIron ADX code flash and USB drives.
• Copying files between an tftp server, ServerIron ADX code flash, and USB drives.
• Renaming files on USB drives.
• Deleting files from USB drives and ServerIron ADX code flash.
• Formatting USB drives.
• Testing USB drives.