Technical data

32 ServerIron ADX Administration Guide

53-1002434-01

Configuring DNS

To display information about SNTP associations, enter the following command.

Syntax: show sntp associations

The following table describes the information displayed by the show sntp associations command.

Configuring DNS

This section contains information on configuring DNS.

Defining a domain name

You can define a domain name for a range of addresses on the ServerIron ADX. This will eliminate

the need for a user to type in the domain name. It will automatically be appended to the hostname.

This field... Indicates...

unsynchronized System is not synchronized to an NTP peer.

synchronized System is synchronized to an NTP peer.

stratum NTP stratum level of this system

reference clock IP Address of the peer (if any) to which the unit is synchronized

precision Precision of this system's clock (in Hz)

reference time Reference time stamp

clock offset Offset of clock to synchronized peer

root delay Total delay along the path to the root clock

root dispersion Dispersion of the root path

peer dispersion Dispersion of the synchronized peer

This field... Displays...

(leading character) One or both of the following:

* Synchronized to this peer

~ Peer is statically configured

address IP address of the peer

ref clock IP address of the peer’s reference clock

st NTP stratum level of the peer

when Amount of time since the last NTP packet was received from the peer

poll Poll interval in seconds

delay Round trip delay in milliseconds

disp Dispersion in seconds

ServerIronADX# show sntp associations

address ref clock st when poll delay disp

~207.95.6.102 0.0.0.0 16 202 4 0.0 5.45

~207.95.6.101 0.0.0.0 16 202 0 0.0 0.0

* synced, ~ configured