Technical data

52 ServerIron ADX Administration Guide
53-1002434-01
High availability configurations
1
ServerIronADXA# configure sync-terminal
ServerIronADXA#(config-sync)# server virtual v1 10.10.1.1
ServerIronADXA(config-sync-vs-v1)# port http
ServerIronADXA(config-sync-vs-v1)# exit
ServerIronADXA(config-sync)# write mem
ServerIronADXA(config-sync)# exit
Syntax: configure sync-terminal
Once you enter the configure sync-terminal level, commands entered on ServerIron ADX A are
duplicated on ServerIron ADX B. The commands continue to be duplicated on ServerIron ADX B
until you exit out of the configure sync-terminal level.
Enter a “?” at the CLI command line to display the list of commands allowed for synchronization.
This list can vary from device to device and from release to release.
If you enter an invalid command while in configure sync-terminal or if the command you entered
cannot be accepted by the destination ServerIron ADX, a message appears.
Example
Peer message: real server 1 not found
Also, some commands, such as no server real, may take a few seconds to process before the CLI is
available for the next command.
To see if the configuration entered at the configure sync-terminal level was successfully duplicated
on the destination ServerIron ADX, enter the show run command on the destination ServerIron
ADX. The duplicated configuration should be displayed.
Block-by-block synchronization
This feature allows you to synchronize sections (blocks) of an ServerIron ADX’s configuration across
a network.
ServerIronADX(config)# config-sync sender e 2/21 mac 000c.db2b.ad34
ServerIronADX(config)# exit
ServerIronADX# config sync-terminal
ServerIronADX(sync-config)# ?
agent-health-report-interval
csw-policy content switching policy name
csw-rule content switching rule
end End Configuration level and go to Privileged Level
exit Exit current level
extern-config-file extern configuration file
gslb Configure Global SLB features
gslb-host-policy GSLB host policy name
healthck Health-check
http HTTP protocol
ip IP settings
no Undo/disable commands
quit Exit to User level
rshow Remote show system information
server Set SLB features
session Set session parameters
show Show system inform
write Write running configuration to flash or terminal