Technical data

54 ServerIron ADX Administration Guide

53-1002434-01

Displaying system information

ServerIronADXA# configure terminal

ServerIronADXA(config)# config-sync port-profile all

This may remove some configuration on the peer box.

Are you sure? (enter ’y’ or ’n’): y

Syntax: config-sync port-profile <port-number>|all

The config-sync real-server command synchronizes the device’s port profile configuration with the

peer. The command first removes the existing port profiles on the peer before applying the new

configuration.

Synchronizing all of the content switching policy and rule configurations

To synchronize all of the ServerIron ADX’s content switching policy and rule configurations, enter

commands such as the following.

ServerIronADXA# configure terminal

ServerIronADXA(config)# config-sync csw all

This will first remove all the csw policies/rules on the peer box if already

exists.

Are you sure? (enter 'y' or 'n'):

Syntax: config-sync csw all

The config-sync csw all command synchronizes all of the device’s csw policies and rules

configuration with the peer; however, the association of the policies and rules with the virtual

server is not retained. Also note that the config-sync csw all command first removes the existing

content switching policies and rules on the peer before it applies the new configuration.

NOTE

The config-sync real | vip | slb commands will first delete the corresponding real or virtual servers

on the peer. If the real or virtual servers on the peer are handling traffic, the deletion may fail, which

would prevent the new real or virtual servers from being created. Consequently, you should ensure

there are no sessions on the corresponding real or virtual servers on the peer prior to issuing these

commands.

Displaying system information

To view the software and hardware details for the system, enter the following command.