Technical data
136 ServerIron ADX NAT64 Configuration Guide
53-1002444-02
Displaying NAT information
7
DRAFT: BROCADE CONFIDENTIAL
Displaying NAT redundancy information
You can display information about the state of the static NAT IP or NAT pool (dynamic), the MAC
address used, and the configured priority. The MAC address used for the NAT IP is a special
construct, where the last three bytes of the MAC address are derived from the shared NAT IP
address (similar to the symmetric MAC).
To display NAT redundancy information, enter the following command.
The two Priority options are High and Low. That is, 2 or 1.
The two State options are Active and Standby.
Syntax: show ip nat redundancy
Displaying VRRPE information
To display VRRPE information, enter the following command.
Inside local The private address mapped to the Internet address listed in the Inside global
field for inside NAT.
Outside global The destination of the traffic. If PAT is enabled, the TCP or UDP port also is
shown.
NOTE: Currently, outside NAT is not supported.
Outside local The destination of the traffic. If PAT is enabled, the TCP or UDP port also is
shown.
NOTE: Currently, outside NAT is not supported.
TABLE 16 Display fields for show ip nat translation (Continued)
Field Description
ServerIronADX# show ip nat redundancy (on active)
NAT Pool Start IP: 10.1.1.150 Mac address: 020c.db01.0196
State: Active Priority: High
NAT Pool Start IP: 10.1.1.91 Mac address: 020c.db01.015b
State: Active Priority: High
NAT Pool Start IP: 10.1.1.92 Mac address: 020c.db01.015c
State: Active Priority: High
NAT Pool Start IP: 10.1.1.95 Mac address: 020c.db01.015f
State: Active Priority: High
ServerIronADX# show ip nat redundancy (on standby)
NAT Pool Start IP: 10.1.1.150 Mac address: 020c.db01.0196
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
NAT Pool Start IP: 10.1.1.91 Mac address: 020c.db01.015b
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
NAT Pool Start IP: 10.1.1.92 Mac address: 020c.db01.015c
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20
NAT Pool Start IP: 10.1.1.95 Mac address: 020c.db01.015f
State: Standby Priority: Low
Standby Idle count: 0 Threshold: 20