Technical data

ServerIron ADX NAT64 Configuration Guide 19
53-1002444-02
Displaying NAT64 information
2
DRAFT: BROCADE CONFIDENTIAL
ServerIron ADX(config)# nat64 pool nat64-zone1 201.1.1.1 201.1.1.20 prefix-length
24 port-pool-range 2
NOTE
Active-active NAT configurations use the server active-active-port ethernet <portnum> vlan-id
<vlan-number> command to identify the port that connects the ServerIron ADX to its Active-Active
partner. The port you specify must be in its own port-based VLAN. The configuration is mandatory
on both HA boxes. For more information, refer to “Configuring VLAN option for Active-Active links” in
the ServerIron ADX Server Load Balancing Guide.
For details on configuring the nat64 pool command, refer to “Configuring basic IPv4 NAT address
pools” on page 10.
Enabling inject active only for HA
The nat64 inject-active-only command ensures that only an active ServerIron ADX will inject the
static route and the standby ServerIron ADX will withdraw the static routes. Without this command
(default configuration), both the active and standby ServerIron ADXs will inject the route.
ServerIron ADX(config)# nat64 inject-active-only
Syntax: [no] nat64 inject-active-only
NOTE
This command only applies to the IPv6-only client to IPv4 resource configuration as described in this
chapter because it is performed in the stateful mode and maintains session relationships.
Displaying NAT64 information
This section includes the following topics, which document the show commands for displaying
information about stateful NAT64 configurations:
• “Displaying session information” on page 19
• “Displaying NAT64 translations” on page 20
• “Displaying NAT64 statistics” on page 21
• “Displaying NAT64 resources” on page 25
NOTE
Many of these commands can also be used to view information about stateless NAT64 and stateless
NAT46 configurations as well.
Displaying session information
Use the show session all command at the rconsole to display sessions on the ServerIron ADX
including stateful NAT64 sessions. Sessions are not created for stateless NAT64 or stateless
NAT46 and the command cannot be used for stateless configurations.
NAT64 sessions are indicated by a unique session type in the output. This output is displayed as
follows.
ServerIron ADX# rconsole 1 1