Technical data

58 ServerIron ADX NAT64 Configuration Guide
53-1002444-02
Debugging NAT46 configurations
4
DRAFT: BROCADE CONFIDENTIAL
The all parameter clears all of the configured stateless static NAT46 IPv4-IPv6 address mappings.
Clearing stateless NAT46 statistics
Use the clear nat64 statistics command to clear stateless NAT46 statistics on a ServerIron ADX.
This command is issued as follows:
ServerIron ADX# clear nat64 statistics
Syntax: clear nat64 statistics
Debugging NAT46 configurations
Use the debug nat64 command to enable diagnostic debugging of NAT46 configurations.
To debug a NAT46 configuration, you must use the stateless operand such as in the following
example:
ServerIron ADX# debug nat64 stateless 192.0.2.1
In the example, diagnostic debugging is enabled for the IPv4 host at the IP address 192.0.2.1.
Syntax: debug nat64 stateless all | <ipv4-address> | <ipv6-address>
The all operand displays debug information for all IPv4 and IPv6 host IP addresses.
The <ipv4-address> variable displays debug information for a specific IPv4 host IP address.
The <ipv6-address> variable displays debug information for a specific IPv6 host IP address.
Use the undebug command to disable debugging.