Technical data

190 ServerIron ADX Graphical User Interface Guide
53-1002382-01
Uploading the software
15
The system continuously polls for the upload complete status. After upload is complete, the
page gets auto refreshed to show the latest information. The system polls for 4 minutes
maximum to server to respond and in case of no response from the server, the system prompts
you to try again.
4. Click Upload and Reboot to reboot the device after uploading the software image to the device.
The system follows the standard upload process. After upload is complete, before rebooting
the device, the system checks the version of the uploaded image. If the image version is lower
than 12.4, the system displays a warning message that the image does not support current
web system and you will lose connectivity to this system after reboot.
If the image version is 12.4 or later, the system checks for the image type and displays a
warning message that you will have to log in again to the system after reboot, if the current
image and the image trying to upload are different.
During device reboot, the system continuously polls for the reboot success status. If the reboot
is successful, the system is reloaded with the current page.
The system polls 3 minutes maximum for the server to respond on the reboot status and in
case of no response, will suggest you to log in again to the system to access the latest
information.
The Software Upload page also displays the information about the software running on the
device. Table 46 describes the fields in the Software Information table.
TABLE 46 Software Information fields
Field Description
Image Specifies the running image and image flash on the device, which
can be one of the following:
• Running (P)- Indicates the image is running from primary
flash.
• Running (S) - Indicates the image is running from secondary
flash.
• Primary - Indicates the image is stored in the primary flash.
• Secondary - Indicates the image is stored in the secondary
flash.
• Boot - Indicates the boot image is used to bring up the device
to load the primary or secondary image.
Version Displays the release version of the software image.
Image Name Displays the name of the software image.
Build Type Displays the type of the build running on the device, which can be
one of the following:
• Router - Indicates the device is loaded with the router build.
• Switch - Indicates the device is loaded with the switch build.
Build Date Displays the date on which the image was released.