Technical data

ServerIron ADX Graphical User Interface Guide 191
53-1002382-01
Chapter
16
Restarting the System
In this chapter
•System restart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 191
System restart
To reboot the device, perform the following steps within the Maintain tab.
1. Click Reboot from the menu bar.
The Reboot page is displayed, as shown in Figure 142.
FIGURE 142 Rebooting the device
2. Select Primary or Secondary for image flash. By default, the system is configured to boot from
the primary memory.
3. Select Always reboot using the selected image flash check box to set the selected image flash
as the configured boot image.
4. Select Save Configuration check box to specify if the running configuration must be saved
before reboot.
NOTE
If you select the Always reboot using the selected image flash check box, the Save
Configuration check box is selected and the running configuration is saved automatically.
5. Click Reboot to reboot the device.