Technical data

ServerIron ADX Graphical User Interface Guide 197

53-1002382-01

Chapter

Accessing the CLI

In this chapter

•CLI Access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 197

CLI Access

The ADX web interface enables you to run CLI commands to configure the features that are not

supported in the web interface. You can use the CLI access feature available in web interface to run

the CLI commands in a batch to request and change the configuration information on ADX device.

To run CLI commands using the web interface, perform the following steps within the Maintain tab.

1. Click CLI Access from the menu bar.

The CLI Access page is displayed, as shown in Figure 145.

FIGURE 145 CLI Access

NOTE

The users with operator and manager privilege can run the CLI commands from the GUI. If you are

a read-only user. You can only view the CLI Access page.

2. Enter the CLI commands in the field under the Enter a batch of up to 10 CLI commands that

you would like to send to the ADX.

NOTE

The maximum number of CLI Commands that you can run from the web interface is 10.

However, if any command fails to execute, the device will continue to process the remaining

commands and return the response of the commands that are executed.

3. Perform one of the following actions: