Technical data

20 ServerIron ADX Graphical User Interface Guide

53-1002412-01

General settings

3. Under System, provide the following information:

• Hostname: Enter a host name for the device; for example, ADXHost. When you configure a

host name, the name replaces the default system name. The name can contain up to 32

alphanumeric characters.

• Serial Number: Displays the serial number of the device. The field is non-editable.

4. Under SNTP, provide the following information:

• Address: Enter the SNTP server address to configure the device to consult SNTP servers

for the current system time and date. You can add up to three SNTP server addresses.

• Interval: Enter the SNTP interval in seconds for the device to poll for clock updates from

the SNTP server. The range is from 5 through 3600 seconds. The default interval is 5

seconds.

5. Under Chassis, provide the following information:

• Name: Enter the chassis name to assign an administrative ID to the device.

• Poll Interval: Enter the poll interval in seconds for the software to read the temperature

sensor and poll other hardware sensors according to the set value. The range is from 0

through 65535 seconds. The default interval is 5 seconds.

6. Click Apply to save your entries.

Click Reset to revert the configuration to the previous configured values.

NOTE

All the configuration changes performed in the web interface are stored in the running configuration.

Click the Save icon to save the running configuration to the startup configuration.

For more information on the basic system settings, refer to the ServerIron ADX Switch and Router

Guide.

You can use the links under Quick Links to helpful Tasks, to navigate to real servers, virtual servers,

health checks, and content switching policy configurations.

Changing the system limits

You can set the system memory consumption limits to control the device. To configure the system

limits on the device, perform the following steps within the Configure tab.

1. Click System on the menu bar.

2. From the sidebar, select General, and then select System Limits.