Technical data

24 ServerIron ADX Graphical User Interface Guide
53-1002412-01
High Availability
5
The High Availability page is displayed, as shown in Figure 7.
FIGURE 7 High Availability
3. Select Hot Standby. The Hot Standby page is displayed, as shown in Figure 8.
FIGURE 8 Configuring hot standby
4. Under the Basic tab, provide the following information:
• Sync VLAN: Select a port-specific VLAN from the list.
• Sync Port: Select the hot standby port from the list. Placing the hot standby port in its own
VLAN prevents unnecessary traffic from going over the directly connected backup link.
• Shared MAC: Specify the MAC address of one of the devices. You must use a chassis MAC
address of the devices, not the MAC address of the backup ports.
• Router Ports: Select the number of router ports from the Available list and click Add to
specify the ports for the active device. Click Remove to remove an added router port. Both
the devices in the hot standby must use the same router-ports numbers.