Technical data

36 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Configuring network interfaces and IP addresses
6
The IP interface - 1 page tab is displayed, as shown in Figure 21.
FIGURE 21 Editing an interface
4. Provide the following information:
• Interface ID: Displays the ID assigned to the interface.
• MAC Address: Displays the MAC address of the interface.
• Interface name: Enter a unique name for the interface. The interface name is represented
by the physical and logical parts.
• Auto Negotiation: Click the Enable check box to deactivate the auto-negotiation feature. By
default, the auto-negotiation feature is enabled to create a link between the master and
the backup devices.
NOTE
The Speed, Duplex, and FlowControl fields are enabled only if you disable the auto-negotiation
feature.
• Speed: Click 10M, 100M, 1G, or 10G to set the speed for the port.
• Duplex: Click Half or Full to set the duplex mode for the port.
• FlowControl: Click the Enable check box to deactivate flow control. By default, the flow
control is enabled.
5. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
For more information on the network interfaces, refer to the ServerIron ADX Switch and Router
Guide.