Technical data

ServerIron ADX Graphical User Interface Guide 41
53-1002412-01
Configuring source IP addresses
6
The Summary page is displayed, as shown in Figure 26.
FIGURE 26 Source IP summary
The Summary page displays the list of configured source IP addresses. Each entry in the list
includes IP address, subnet, default gateway, and the source port for the real servers.
3. Click New at the bottom of the Summary page.
The Source IPs - new page tab is displayed, as shown in Figure 27.
FIGURE 27 Configuring source NAT IP
4. Provide the following information:
• IP Type: Click Source IP, Source NAT IP, or Source Standby IP to enter respective
configurations.
• IP Address: Enter the source IP address.
• Subnet Mask: Enter the subnet mask or select the Use Prefix check box and enter the
prefix length. The range is from 0 through 60. The default is 24.
• Default Gateway: Enter the IP address of the default gateway for the device.
• Source Port Range: Select Lower Port Range or Higher Port Range to specify the device
with port range to indicate higher priority for the source NAT IP.
NOTE
The Source Port Range field is enabled only when you select the IP type as Source NAT IP