Technical data

42 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Configuring source IP addresses
6
• Allocate Source Port per Real Server: Select the check box to if you want to allocate the
source port on the real server.
5. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
To delete the configured source IP address information, select an entry from the Summary
table and click Delete.
For more information on the source NAT IP, refer to the ServerIron ADX Security Guide.
Configuring source NAT IP addresses on router code
To define source IP address on the device, perform the following steps within the Configure tab.
1. Click Network on the menu bar.
2. From the sidebar, select Source NAT IPs.
The Summary page is displayed, as shown in Figure 28.
FIGURE 28 Source NAT IP summary
The Summary page displays the list of configured source NAT IP addresses. Each entry in the list
includes IP address, subnet, default gateway, and the source port for the real servers.
3. Click New at the bottom of the Summary page.