Technical data

ServerIron ADX Graphical User Interface Guide 43
53-1002412-01
Configuring VLANs
6
The Source NAT IPs - new page tab is displayed, as shown in Figure 29.
FIGURE 29 Configuring source NAT IP
4. Provide the following information:
• IP Address: Enter the source IP address for sending packets to the real server.
• Subnet Mask: For IPv4, enter the subnet mask in class-based format. For IPv6, select the
Use Prefix check box to enter the prefix length.
• Default Gateway: Enter the IP address of the default gateway.
• Source Port Range: Click Lower Port Range or Higher Port Range to specify the device with
port range to indicate higher priority for the source NAT IP.
• Allocate Source Port per Real Server: Select the check box if you want to allocate the
source port on the real server.
5. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
To delete the configured source NAT IP address information, select an entry from the Summary
table and click Delete.
For more information on the source IP addresses, refer to the ServerIron ADX Server Load
Balancing Guide.
Configuring VLANs
You can configure two types of Virtual Local Area Networks (VLANs); port-based VLANs and IP
subnet VLANs. To configure VLAN on the device, perform the following steps within the Configure
tab.
1. Click Network on the menu bar.
2. From the sidebar, select VLAN.