Technical data

52 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Virtual servers
7
• UDP Age: Specify the number of minutes the device allows a UDP connection to remain
inactive before closing the connection. The range is from 2 through 60 minutes. The
default value is 5 minutes.
• Sticky Age: Specify the number of minutes a sticky server connection can remain inactive
before aging out. The range is from 2 through 60 minutes. The default value is 5 minutes.
• Under VIP Route Health Injection, provide the following information:
 Advertise VIP Route: Select the Enable check box to advertise a route in the network
containing the virtual server, even if the virtual server is unavailable. Select the Inject
always check box for route injection to occur always.
 Subnet Length: Enter the subnet mask length as an index number. The range is from 1
through 32.
7. Cl ick Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
To modify the configured virtual server information, in the summary table, select an entry and
click Edit or double-click the entry. Click Delete to delete a virtual server configuration.
For more information on configuring virtual servers, refer to the ServerIron ADX Server Load
Balancing Guide.
Creating a virtual server port
After defining the virtual server, you can add TCP or UDP ports to the virtual servers for receiving
service requests from the client.
To configure a virtual server port on the device, perform the following steps within the Configure
tab.
1. Click Traffic on the menu bar.
2. From the sidebar, select Virtual Servers.
The Configure Virtual Servers page is displayed.
3. Select a virtual server from the list in Configure Virtual Servers table and click Ports.
The Configure Virtual Server Ports page tab is displayed, as shown in Figure 36.
FIGURE 36 Virtual server ports