Technical data

ServerIron ADX Graphical User Interface Guide 59
53-1002412-01
Real servers
7
The Configure Real Sever - new page tab is displayed. By default, Basic configuration tab is
displayed, as shown in Figure 43.
FIGURE 43 Configuring real server basic parameters
4. Under Basic tab, enter the following information:
• Click Create one Real Server for creating a real server.
• Real Server Name: Enter the name of the real server.
• IP Address: Enter the IP address of the real server. You can configure both IPv4 and IPv6
addresses.
• Description: Optionally, enter a description for the real server.
• Alias Name: Optionally, enter the name of the alias.
• Admin State: Click the Enable check box to disable the real server. By default, the real
server is enabled.
• Remote: Select the Enable (only editable at creation time) check box to designate the real
server to be a remote server, if the server is attached through one or more router hops.
You can configure only during the creation of the real server.
• Backup: Select the Enable check box to designate the real server to be a backup server if
all the primary servers are unavailable for the requested application.
5. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
To modify the configured real server information, in the summary table, select an entry and
click Edit or double-click the entry. Click Delete to delete a real server configuration.
For more information on configuring real servers, refer to the ServerIron ADX Server Load
Balancing Guide.