Technical data

ServerIron ADX Graphical User Interface Guide 61
53-1002412-01
Real servers
7
The Advanced tab is displayed, as shown in Figure 45.
FIGURE 45 Configuring advanced parameters
8. Provide the following information:
• Ping Health Check: Select the Enable check box to enable Layer 3 health checks to the
real server IP addresses.
• Source NAT: Select the Enable check box to allow the device to use a source IP address as
the source for packets sent to the real server.
• Source-NAT ACL: Select the check box to configure the device to apply source NAT for the
traffic received from specified source IP addresses, by creating an access control list,
which specifies a permit action for the traffic from the source IP address.
• ACL ID: Enter the identifier for the access list in the source NAT. The range is from 1
through 99. The default value is 1.
• Under Rate Limiting, provide the following information:
 Maximum Connections: Enter the maximum number of sessions the device will
maintain in its session table. The range is from 1 through 2,000,000.
 Maximum TCP Connection Rate: Enter the maximum number of TCP connections per
second. The range is from 1 through 4,294,967,295.
 Maximum UDP Connection Rate: Enter the maximum number of UDP connections per
second. The range is from 1 through 4,294,967,295.
9. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
For more information on configuring real servers, refer to the ServerIron ADX Server Load
Balancing Guide.