Technical data

64 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Real servers
7
To modify the configured real server ports, in the summary table, select an entry and click Edit
or double-click the entry. You can also delete a configuration by clicking Delete.
For more information on configuring real server ports, refer to the ServerIron ADX Server Load
Balancing Guide.
Configuring health check parameters for a real server port
To configure the health check parameters for a real server port on the device, perform the following
steps within the Configure tab.
1. Click Traffic on the menu bar.
2. From the sidebar, select Real Servers.
3. Select the real server from the list in Configure Real Servers page and click Port
4. Click New at the bottom of the Configure Real Servers page.
5. Click Health Check tab.
The Health Check page is displayed, as shown in Figure 48.
FIGURE 48 Configuring health check parameters
6. Provide the following information:
• Periodic Health Check: Select the Enable check box to enable the Layer 3 health check for
the local real server.
• Select the L4 Only check box to enable a Layer 4 check, if the application port is not one of
the applications that is known to the device.
• Element Health Check: Select a health check on the device to allow a health check that is
customized for a given application server.
• Port Policy: Select a port policy from the list to reduce the configuration required for health
checks and provide more flexibility while configuring health checks.