Technical data

ServerIron ADX Graphical User Interface Guide 65
53-1002412-01
Real servers
7
• Bringup Intervals: Enter the Layer 4 and Layer 7 bringup intervals to enable the health
check policy during initial bringup of the server in seconds. The range is from 1 through
255 seconds.
7. Under Specific settings to HTTP, enter the following information:
• URL: Enter the URL name to specify whether the HTTP health check performs a GET or
HEAD request while customizing the Layer 7 information sent with the health check.
• Status Codes: Enter the status code for the four groups to change the HTTP status codes
that the device accepts as valid responses. The range is from 100 through 999.
• Content Match: Select the content match from the list to attach a match list for an HTTP
content verification health check to the real server.
• Health Check Type: Click one of the following options:
 Simple—To perform the simple health check.
 Complete—To perform the complete health check.
8. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
To modify the configured real server ports, in the summary table, select an entry and click Edit
or double-click the entry. You can also delete a configuration by clicking Delete.
For more information on configuring health check on real servers ports, refer to the ServerIron ADX
Server Load Balancing Guide.
Enabling or disabling a real server
You can enable or disable a real server from the Configure Real Servers page.
To enable or disable a real server on the device, perform the following steps within the Configure
tab.
1. Click Traffic on the menu bar.
2. From the sidebar, select Real Servers.
The list of the real servers in the system is displayed on the Configure Real Servers page, as
shown in Figure 41.
FIGURE 49 Enabling a real server