Technical data

72 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Health checks
7
6. Click Apply to save your entries.
Click Reset to revert the configuration to the previous configured values.
For more information on configuring port profiles, refer to the ServerIron ADX Server Load
Balancing Guide.
Defining advanced parameters for a port profile
To define advanced parameters for a port profile on the device, perform the following steps within
the Configure tab.
1. Click Traffic on the menu bar.
2. From the sidebar, select Health Checks, and then select Port Profiles.
3. Click New at the bottom of the Port Profiles page.
The Port Profile - new page tab is displayed.
4. Click Advanced tab.
The Advanced tab is displayed, as shown in Figure 56.
FIGURE 56 Configuring advanced parameters
5. Provide the following information:
• Use Master Port Health Check: Select the Enable check box for the usage of master port
health check.
• Fast Port Bringup: Select the Enable check box to increase the speed of the bringup
process by sending more health checks at a time.
• L4 Interval: Specify the interval at which the device must perform the Layer 4 check. The
range is from 1 through 120 seconds. The default is 5 seconds.
• L7 Interval: Specify the interval at which the device must perform Layer 7 health check.
The range is from 1 through 120 seconds. The default is 5 seconds.