Technical data

86 ServerIron ADX Graphical User Interface Guide
53-1002412-01
Content switching
7
XML TAG Allows the device to make
a load balancing decision
based on the contents of
an XML tag in an
incoming packet.
Under the Setting for XML Tag Rule, provide the following
information:
• XML Tag Name: Enter the name of the XML tag.
• Operator: Select one of the following operators from the list:
- Prefix—To match if the XML tag begins with the specified
prefix.
- Suffix—To match if the XML tag begins with the specified
suffix.
- Pattern—To match if the specified pattern exists anywhere
within the XML tag.
- Equals—To match if the XML tag is equal to the specified
value.
- Exists—To match if the XML tag exists in the incoming
packet.
- Search—To match if the XML tag contains any one of the
specified values.
• Value: Enter a value that has to match with the XML tag.
TCP
Content
Allows the device to make
a load balancing decision
based on the TCP content
in an incoming packet,
depending upon the port
type. You can define up to
520 unique TCP rules.
Under the Settings for TCP Content Rule, provide the following
information:
• Operator: Select one of the following operators from the list:
- Prefix—To match if the TCP content begins with the
specified prefix.
- Suffix—To match if the TCP content begins with the
specified suffix.
- Pattern—To match if the specified pattern exists anywhere
within the TCP content.
- Equals—To match if the TCP content is equal to the
specified value.
- Exists—To match if the TCP content exists in the incoming
packet.
- Search—To match if the TCP content contains any one of
the specified values.
• Value: Enter a value that has to match with the TCP content.
• Offset: Enter the value from where to begin scanning.
UDP
Content
Allows the device to make
a load balancing decision
based on the UDP
content in an incoming
packet, depending upon
the port type. You can
define up to 520 unique
UDP rules.
Under the Settings for UDP Content Rule, provide the following
information:
• Operator: Select one of the following operators from the list:
• Prefix—To match if the UDP content begins with the
specified prefix.
• Suffix—To match if the UDP content begins with the
specified suffix.
• Pattern—To match if the specified pattern exists anywhere
within the UDP content.
• Equals—To match if the UDP content is equal to the
specified value.
• Exists—To match if the UDP content exists in the incoming
packet.
• Search—To match if the UDP content contains any one of
the specified values.
• Value: Enter a value that has to match with the UDP content.
• Offset: Enter the value from where to begin scanning.
TABLE 4 Rule type settings (Continued)
Rule Type Function Your Action