Specifications

Fabric OS Commands
272 Fabric OS Version 3.1.x/4.1.x Reference Guide
would contain all devices connected to switch 2, ports 12 and 14, and the device
with a WWN of "10:00:00:60:69:00:00:8a" (either Node Name or Port Name)
whichever port in the fabric it is connected to. The target connected to switch 2,
port 12 would be assigned an ALPA value of 0xE2, and the target connected to
port switch 2, port 14 would be assigned an ALPA value of 0xE8. Finally, the
ALPA assigned to the target identified by the WWN would be assigned a value of
0xEF.
Preferred ALPA assignments given to a Domain Port that is not a public N_Port
device are ignored, and the fazone is created without error.
Note: This command does not change the defined configuration (which you can view
using the cfgShow command) until the cfgSave command is issued. For the
change to become effective, an appropriate Fabric Assist zone configuration must be
enabled using the cfgEnable command. For the change to be preserved across
switch reboots, it must be saved to non-volatile memory using the cfgSave
command.
When security is enabled, this command can only be issued from the Primary FCS
switch. See “Security Commands” on page 941.
Operands
The following operands are required:
fazoneName
Specify a name for the Fabric Assist zone. The
name must be enclosed in quotation marks. This
operand is required.
member
Specify a member or list of members to add to a
Fabric Assist zone. The list must be enclosed in
quotation marks, and each member must be
separated by a semicolon. A member can be
specified by one or more of the following methods:
■ For V3.1.x, enter a fabric domain and
physical port number pair.
■ For V4.1.x, enter a fabric domain and area
number pair. View the area numbers for ports
using the switchShow command.
■ WWNs.
■ Fabric Assist zone alias names.
■ Exactly one Fabric Assist host member.
This operand is required.