Specifications

Fabric OS Commands
520 Fabric OS Version 3.1.x/4.1.x Reference Guide
Operands
This command has the following operand:
Example
To display filter monitor traffic on blade 2 port 5 at an interval of every 6 seconds:
slotnumber
(V4.1.x only)
Specify the slot number for a StorageWorks Core switch.
For all other switches this operand is not required. The slot
number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot
number (1 through 4, or 7 through 10), and port number
(0 through 15).
The StorageWorks Core switch has a total of 1–10 slots.
Slot number 5 and 6 are control processor cards, and slot 1
through 4, and 7 through 10, are port cards. On each port
card, there are 16 ports counted from the bottom, 0 to 15.
portnumber Specify a port number. Valid values for port number vary
depending on the switch type. This operand is required.
interval Specify an interval in seconds. This operand is optional.
switch:admin> perfshowfiltermonitor 2/5, 6
perfShowFilterMonitor 2/5, 6
0 1 2 3 4 5 6
#Frames #CMDs #CMDs #Frames #Frames #CMDs #CMDs
---------------------------------------------------------------
0 0 0 0 0 0 0
26k 187 681 682 682 494 187
26k 177 711 710 710 534 176
26k 184 734 734 734 550 184
26k 182 649 649 649 467 182
26k 188 754 755 755 567 184
26k 183 716 716 717 534 183
26k 167 657 656 655 488 167
26k 179 749 749 749 570 179
26k 164 752 752 752 588 164
26k 190 700 700 700 510 190
26k 181 701 701 701 520 181
26k 200 750 750 751 550 201
26k 180 692 692 691 512 179
26k 179 696 696 696 517 179
26k 187 720 720 720 533 187
26k 200 722 722 722 522 200
26k 204 717 717 717 513 204