Configuration Guide (Supporting R2.2.0.0) Owner's manual

960 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
Simple Network Management Protocol
FIGURE 260 Creating an SNMP Group
To show SNMP groups:
1. Click Administration, SNMP.
2. Select Configure Group from the Step list.
3. Select Show from the Action list.
FIGURE 261 Showing SNMP Groups
Setting Community Access Strings
Use the Administration > SNMP (Configure User - Add Community) page to configure up to five
community strings authorized for management access by clients using SNMP v1 and v2c. For
security reasons, you should consider removing the default strings.
CLI References
• “snmp-server community” on page 107
Parameters
These parameters are displayed:
• Community String – A community string that acts like a password and permits access to the
SNMP protocol. Range: 1-32 characters, case sensitive
Default strings: “public” (Read-Only), “private” (Read/Write)