Configuration Guide (Supporting R2.2.0.0) Owner's manual

1046 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
OAM Configuration
Displaying Results of Remote Loop Back Testing
Use the Administration > OAM > Remote Loop Back (Show Test Result) page to display the results
of remote loop back testing for each port for which this information is available.
CLI References
• “show efm oam remote-loopback interface” on page 577
Parameters
These parameters are displayed:
• Port – Port identifier. (Range: 1-12)
• Packets Transmitted – The number of loop back frames transmitted during the last loop back
test on this interface.
• Packets Received – The number of loop back frames received during the last loop back test on
this interface.
• Loss Rate – The percentage of packets transmitted for which there was no response.
Interface
To display the results of remote loop back testing for each port for which this information is
available:
1. Click Administration, OAM, Remote Loop Back.
2. Select Show Test Result from the Action list.
FIGURE 332 Displaying the Results of Remote Loop Back Testing