Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 101
53-1002651-02
5
Time Range
Time Range
This section describes the commands used to sets a time range for use by other functions, such as
Access Control Lists.
time-range
This command specifies the name of a time range, and enters time range configuration mode. Use
the no form to remove a previously specified time range.
Syntax
[no] time-range name
name - Name of the time range. (Range: 1-16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
This command sets a time range for use by other functions, such as Access Control Lists.
Example
Console(config)#time-range r&d
Console(config-time-range)#
Related Commands
“Access Control Lists” on page 233
TABLE 25 Time Range Commands
Command Function Mode
time-range Specifies the name of a time range, and enters time range
configuration mode
GC
absolute Sets the time range for the execution of a command TR
periodic Sets the time range for the periodic execution of a command TR
show time-range Shows configured time ranges. PE