Configuration Guide (Supporting R2.2.0.0) Owner's manual

Brocade 6910 Ethernet Access Switch Configuration Guide 225
53-1002651-02
10
ARP Inspection
ARP Inspection
ARP Inspection validates the MAC-to-IP address bindings in Address Resolution Protocol (ARP)
packets. It protects against ARP traffic with invalid address bindings, which forms the basis for
certain “man-in-the-middle” attacks. This is accomplished by intercepting all ARP requests and
responses and verifying each of these packets before the local ARP cache is updated or the packet
is forwarded to the appropriate destination, dropping any invalid ARP packets.
ARP Inspection determines the validity of an ARP packet based on valid IP-to-MAC address bindings
stored in a trusted database – the DHCP snooping binding database. ARP Inspection can also
validate ARP packets against user-configured ARP access control lists (ACLs) for hosts with
statically configured IP addresses.
This section describes commands used to configure ARP Inspection.
ip arp inspection
This command enables ARP Inspection globally on the switch. Use the no form to disable this
function.
Syntax
[no] ip arp inspection
Default Setting
Disabled
TABLE 56 ARP Inspection Commands
Command Function Mode
ip arp inspection Enables ARP Inspection globally on the switch GC
ip arp inspection filter Specifies an ARP ACL to apply to one or more VLANs GC
ip arp inspection log-buffer
logs
Sets the maximum number of entries saved in a log message, and
the rate at these messages are sent
GC
ip arp inspection validate Specifies additional validation of address components in an ARP
packet
GC
ip arp inspection vlan Enables ARP Inspection for a specified VLAN or range of VLANs GC
ip arp inspection limit Sets a rate limit for the ARP packets received on a port IC
ip arp inspection trust Sets a port as trusted, and thus exempted from ARP Inspection IC
show ip arp inspection
configuration
Displays the global configuration settings for ARP Inspection PE
show ip arp inspection
interface
Shows the trust status and inspection rate limit for ports PE
show ip arp inspection log Shows information about entries stored in the log, including the
associated VLAN, port, and address components
PE
show ip arp inspection
statistics
Shows statistics about the number of ARP packets processed, or
dropped for various reasons
PE
show ip arp inspection vlan Shows configuration setting for VLANs, including ARP Inspection
status, the ARP ACL name, and if the DHCP Snooping database is
used after ACL validation is completed
PE