Configuration Guide (Supporting R2.2.0.0) Owner's manual

256 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
12
Interface Commands
Interface Configuration
interface
This command configures an interface type and enters interface configuration mode. Use the no
form with a trunk to remove an inactive interface.
Syntax
[no] interface interface
interface
craft - Management port on the front panel.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4093)
Default Setting
None
show interfaces status Displays status for the specified interface NE, PE
show interfaces switchport Displays the administrative and operational status of an interface NE, PE
show interfaces transceiver Displays the temperature, voltage, bias current, transmit power, and
receive power information on connector type and vendor-related
parameters
PE
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port PE
show cable-diagnostics Shows the results of a cable diagnostics test PE
Loopback Testing
ethernet loopback Loops traffic back from destination port to source port IC
show ethernet loopback
interface
Shows adminstative status for each port, and the associated VLANs PE
show ethernet loopback
resources
Shows the available resources, and those used by loopback testing PE
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
* Enabling hardware-level storm control with this command on a port will disable software-level automatic storm
control on the same port if configured by the command “auto-traffic-control” on page 313.
TABLE 63 Interface Commands (Continued)
Command Function Mode