Configuration Guide User guide

1066 BigIron RX Series Configuration Guide
53-1002484-04
Displaying 802.1x information
34
To display information about the 802.1x configuration on an individual port, enter a command such
as the following.
Syntax: show dot1x config ethernet <slot/port>
The following additional information is displayed in the show dot1x config command for an
interface.
server-timeout When the Authentication Server does not respond to a message sent
from the Client, the amount of time before the BigIron RX retransmits
the message.
Refer to “Specifying a timeout for retransmission of messages to the
authentication server” on page 1062 for information on how to change
this setting.
max-req The number of times the BigIron RX retransmits an EAP-request/identity
frame if it does not receive an EAP-response/identity frame from a Client
(default 2 times).
Refer to “Specifying the number of EAP-request/identity frame
retransmissions” on page 1062 for information on how to change this
setting.
re-authperiod How often the device automatically re-authenticates Clients when
periodic re-authentication is enabled (default 3,600 seconds).
Refer to “Configuring periodic re-authentication” on page 1060 for
information on how to change this setting.
security-hold-time This field is not supported.
Protocol Version The version of the 802.1x protocol in use on the device.
Auth-fail-action The configured authentication-failure action. This can be Restricted
VLAN or Block Traffic.
Mac Session Aging Whether aging for dot1x-mac-sessions has been enabled or disabled for
permitted or denied dot1x-mac-sessions.
Mac Session max-age The configured software aging time for dot1x-mac-sessions.
Maximum Failed Attempts The number of failed authentication attempts, if the
authentication-failure action shows Restricted VLAN,
TABLE 172 Output from the show dot1x command (Continued)
This field... Displays...
BigIron RX# show dot1x config e 1/3
Port 1/3 Configuration:
AuthControlledPortControl : Auto
max-clients : 32
multiple-clients : Enable
filter-strict-security : Enable