Configuration Guide User guide
1162 BigIron RX Series Configuration Guide
53-1002484-04
Displaying IP multicast information
42
Syntax: show ip multicast
This display shows the following information.
Displaying IP multicast statistics
To display IP multicast statistics on a device, enter the following commands at any level of the CLI.
BigIron RX# show ip multicast statistics vlan
IP multicast is enabled - Passive
VLAN ID 1
This field... Displays...
IP multicast traffic snooping state Indicates whether IP multicast traffic snooping is enabled or disabled. If
enabled, it indicates if the feature is configured as passive or active.
IP PIMSM snooping state Indicates if PIM snooping is enabled. If disabled, this line does not
appear.
VLAN ID The port-based VLAN to which the information listed below the VLAN ID
applies. Each port-based VLAN is a separate Layer 2 broadcast domain.
Active The IP address of the device that actively sends IGMP queries.
Router Ports The ports that are connected to routers that support IP multicast.
Report FID The fid and camindex values are used by Brocade Technical Support for
troubleshooting.
Number of Multicast Group The total number of groups for which the VLAN’s ports have received
IGMP group membership reports, join messages, or prune messages.
Group An IP multicast group.
IGMP Report Port The ports in this VLAN on which the device has received IGMP group
membership reports for IP multicast groups. This line is blank if PIM
snooping is enabled.
PIMv2 *G join ports Ports participating in PIM snooping. This line is not displayed if PIM
snooping is disabled.
BigIron RX(config)# show ip multicast
IP multicast is enabled - Passive
IP pimsm snooping is enabled
VLAN ID 23
Active 10.10.10.10 Report ports: 1/1 7/1
Report FID 0X0400
Number of Multicast Groups: 2
1 Group: 225.1.0.291
IGMP report ports :
Mapped mac address : 0100.5e01.001d Fid:0x041b
PIMv2*G join ports : 1/1
2 Group: 225.1.0.24
IGMP report ports : 4/48
Mapped mac address : 0100.5e01.0018 Fid:0x041a
PIMv2*G join ports : 1/1