Configuration Guide User guide

1250 BigIron RX Series Configuration Guide
53-1002484-04
Displaying BGP4+ information
46
You also can display all the dampened routes by using the show ipv6 bgp dampened-paths
command. For more information, refer to “Displaying dampened BGP4+ paths” on page 1243.
Displaying BGP4+ neighbor information
You can display the following information about a switch’s BGP4+ neighbors:
• Configuration information and statistics.
• Router advertisements.
• Route-attribute entries.
• Route flap dampening statistics.
• The last packet containing an error.
• Received Outbound Route Filters (ORFs).
• Routes received from a neighbor.
• BGP4+ Routing Information Base (RIB).
• Received best, not installed best, and unreachable routes.
• Route summary.
Displaying IPv6 neighbor configuration information and statistics
To display BGP4+ neighbor configuration information and statistics, enter the following command
at any level of the CLI.
Reuse The amount of time (in hh:mm:ss) after which the path is again
available.
Path The AS path of the route.
TABLE 208 Route flap dampening statistics
This field... Displays...