Configuration Guide User guide

BigIron RX Series Configuration Guide 1417

53-1002484-04

Appendix

Commands That Require a Reload

Most CLI commands take effect as soon as you enter them. However, a small number of

commands require a software reload to take effect. Table 245 lists the commands.

To place a configuration change made by one of these commands into effect, you must save the

change to the startup-config file, then reload the software. If you reload the software without

saving the change to the startup-config file, the device does not make the change.

To reload the software, you must perform a cold start. To perform a cold start, do one of the

following:

• Enter the reload command at the Privileged EXEC level of the CLI.

• Cycle the power by powering down the device, then powering it on again.

NOTE

The boot system command does not perform a cold start. It performs a warm start.

TABLE 245 Commands that require a software reload

Command See ...

max-frame-size “Setting maximum frame size per PPCR” on page 182

system-max “Displaying and modifying system parameter default settings” on

page 133