Configuration Guide User guide

BigIron RX Series Configuration Guide 1421
53-1002484-04
ACLs (L2)
E
ACLs (L2)
BGP4
ip access-group <num> I <name> in “Configuring standard numbered ACLs” on page 600
“Configuring extended numbered ACLs” on page 602
“Configuring standard or extended named ACLs” on
page 611
ip access-group
<num> in ethernet <portnum>
[
<portnum>...] to <portnum>
“Applying ACLs to a virtual routing interface” on
page 633
ip access-list logging-age
<minutes> “Configuring the Layer 4 session log timer” on
page 634
ip rebind-acl
<num> | <name> | all “Reapplying modified ACLs” on page 633
ip show-acl-service-number “Displaying of TCP/UDP numbers in ACLs” on
page 616
show access-list accounting brief “Displaying accounting statistics for all ACLs” on
page 636
show access-list accounting ethernet [
<slot>/<port> | ve
<ve-number>]
“Displaying statistics for an interface” on page 637
system-max ip-filter-sys
<num> “Enabling support for additional ACL statements” on
page 596
Commands See ...
Commands See ...
access-list <num> permit | deny <src-mac> <mask> |
any
<dest-mac> <mask> | any [<vlan-id> | any [etype
<etype-str>] [log-enable]]
“Creating a Layer 2 ACL table” on page 588
mac access-group
<num> in “Binding a Layer 2 ACL table to an interface” on
page 590
show access-list
<num> “Viewing Layer 2 ACLs” on page 591
system-max l2-acl-table-entries
<max> “Increasing the maximum number of clauses per
Layer 2 ACL table” on page 590
Commands See ...
address-family ipv4 unicast | ipv4 multicast “Entering and exiting the address family
configuration level” on page 826
address-filter
<num> permit | deny <ip-addr> <wildcard>
<mask> <wildcard>
“Filtering specific IP addresses” on page 827
aggregate-address
<ip-addr> <ip-mask> [as-set]
[summary-only] [suppress-map
<map-name>]
[advertise-map
<map-name>] [attribute-map
<map-name>]
“Aggregating routes advertised to BGP4 neighbors”
on page 834