Configuration Guide User guide

1428 BigIron RX Series Configuration Guide
53-1002484-04
IP
E
interface ethernet <slot/port> I loopback <num> “Assigning an IP address to an Ethernet port” on
page 164
“Assigning an IP address to a loopback interface” on
page 165
interface ve
<num> “Assigning an IP address to a virtual interface” on
page 165
ip address
<ip-addr> <ip-mask> |
<ip-addr>/<mask-bits> [ospf-ignore I ospf-passive I
secondary]
“Assigning an IP address to an Ethernet port” on
page 164
“Assigning an IP address to a loopback interface” on
page 165
“Assigning an IP address to a virtual interface” on
page 165
“Configuring the default gateway” on page 167
“Deleting an IP address” on page 166
ip arp-age
<num> “Changing the ARP aging period” on page 192
ip bootp-gateway
<ip-addr> “ip bootp-gateway <ip-addr>” on page 221
ip broadcast-zero “Enabling support for zero-based IP subnet
broadcasts” on page 198
ip default-gateway
<ip-addr><ip-mask> I
<ip-addr>/<mask-bits>
“Configuring the default gateway” on page 167
ip directed-broadcast “Enabling forwarding of directed broadcasts” on
page 197
ip dns domain-name
<name> “Defining a DNS entry” on page 176
ip dns server-address
<ip-addr> [<ip-addr>] [<ip-addr>]
[
<ip-addr>]
“Defining a DNS entry” on page 176
ip dr-aggregate “Dropping traffic sent to the null0 interface in
hardware” on page 205
ip encapsulation snap | ethernet-2 “Changing the encapsulation type” on page 181
ip forward-protocol udp
<udp-port-name> |
<udp-port-num>
“Enabling forwarding for a UDP application” on
page 219
ip helper-address
<ip-addr> “Configuring an IP helper address” on page 221
ip hw-drop-on-def-route “Dropping traffic sent to the null0 interface in
hardware” on page 205
ip icmp echo broadcast-request “Disabling replies to broadcast ping requests” on
page 199
ip icmp redirects “Disabling ICMP redirect messages” on page 200
ip icmp unreachable [network | host | protocol |
administration | fragmentation-needed | port |
source-route-fail]
“Disabling ICMP destination unreachable messages”
on page 199
ip irdp [broadcast | multicast] [holdtime
<seconds>]
[maxadvertinterval
<seconds>] [minadvertinterval
<seconds>] [preference <number>]
“Enabling IRDP globally” on page 216
“Enabling IRDP on an individual port” on page 217
ip load-sharing [
<number>] “Changing the maximum number of load sharing
paths” on page 213
Commands See ...