Configuration Guide User guide

1434 BigIron RX Series Configuration Guide
53-1002484-04
IPv6 basic connectivity
E
IPv6 basic connectivity
Commands See ...
ipv6 enable “Configuring a link-local IPv6 address” on page 1172
ipv6 nd reachable-time
<seconds> “Configuring reachable time for remote IPv6 nodes”
on page 1188
ipv6 unicast-routing “Configuring IPv4 and IPv6 protocol stacks” on
page 1176
clear ipv6 cache [
<ipv6-prefix>/<prefix-length> |
<ipv6-address> | ethernet <port> | tunnel <number> |
ve
<number>]
“Clearing the IPv6 cache” on page 1191
clear ipv6 neighbor [
<ipv6-prefix>/<prefix-length> |
<ipv6-address> | ethernet <port> | ve <number>]
“Clearing IPv6 neighbor information” on page 1192
clear ipv6 route [
<ipv6-prefix>/<prefix-length>] “Clearing IPv6 routes from the IPv6 route table” on
page 1192
clear ipv6 traffic “Clearing IPv6 traffic statistics” on page 1193
ip address
<ip-address> <sub-net-mask> [secondary] “Configuring IPv4 and IPv6 protocol stacks” on
page 1176
ip dns server-address
<ip-addr> [<ip-addr>] [<ip-addr>]
[
<ip-addr>]
“Defining a DNS entry” on page 1177
ipv6 address
<ipv6-address> link-local “Configuring a link-local IPv6 address” on page 1172
ipv6 address
<ipv6-prefix>/<prefix-length> [anycast] “Configuring IPv6 anycast addresses” on page 1172
ipv6 address
<ipv6-prefix>/<prefix-length> [eui-64] “Configuring IPv4 and IPv6 protocol stacks” on
page 1176
ipv6 address
<ipv6-prefix>/<prefix-length> “Configuring a global or site-local IPv6 address” on
page 1170
ipv6 address
<ipv6-prefix>/<prefix-length> eui-64 “Configuring a global or site-local IPv6 address with a
manually configured interface ID” on page 1171
ipv6 dns domain-name
<domain name> “Defining a DNS entry” on page 1177
ipv6 dns server-address
<ipv6-addr> [<ipv6-addr>]
[
<ipv6-addr>] [<ipv6-addr>]
“Defining a DNS entry” on page 1177
ipv6 hop-limit
<number> “Limiting the number of hops an IPv6 packet can
traverse” on page 1190
ipv6 icmp error-interval
<interval> [<number-of-tokens>] “Configuring ICMP rate limiting” on page 1182
ipv6 load-sharing [
<num>] “Changing the maximum number of load sharing
paths for IPv6” on page 1179
ipv6 load-sharing by-host “ECMP load sharing for IPv6” on page 1178
ipv6 mtu
<bytes> “Changing the IPv6 MTU” on page 1189
ipv6 mtu
<value> “Changing the IPv6 MTU” on page 1189
ipv6 nd dad attempt
<number> “Setting neighbor solicitation parameters for
duplicate address detection” on page 1185
ipv6 nd managed-config-flag “Setting IPv6 router advertisement parameters” on
page 1186