Configuration Guide User guide

BigIron RX Series Configuration Guide 1449
53-1002484-04
Port parameters
E
Port parameters
show ip ospf virtual neighbor [<num>] “Displaying OSPF virtual neighbor and link
information” on page 806
show tasks “Displaying CPU utilization and other OSPF tasks” on
page 796
snmp-server trap ospf
<ospf-trap> “Modifying OSPF traps generated” on page 791
summary-address
<ip-addr> <ip-mask> “Configure external route summarization” on
page 782
timers lsa-group-pacing
<secs> “Changing the LSA pacing interval” on page 787
timers spf
<delay> <hold-time> “Modify SPF timers” on page 785
Commands See ...
Commands See ...
config-trunk-ind “Mirror ports for Policy-Based Routing (PBR) traffic”
on page 151
disable “Disabling or re-enabling a port” on page 145
enable “Disabling or re-enabling a port” on page 145
flow-control “Disabling or re-enabling flow control” on page 146
gig-default neg-full-auto | auto-gig | neg-off “Changing the default Gigabit negotiation mode” on
page 146
“Changing the default Gigabit negotiation mode” on
page 146
ip address
<ip-addr> <ip-mask> |
<ip-addr>/<mask-bits>
“Assigning an IP address to a port” on page 144
lock-address ethernet
<portnum> [addr-count <num>] “Wait for all cards feature” on page 147
monitor
ethe-port-monitored
<portnum> | named-port-monitored
<portname> ethernet | <portnum>
in | out | both
“Mirror ports for Policy-Based Routing (PBR) traffic”
on page 151
phy-mode wan “Enabling WAN PHY mode support” on page 153
port-name
<text> “Assigning a port name” on page 143
qd-flow sink
<sinking-threshold> sunk <sunk-threshold>
slot
<slot>
“Specifying threshold values for flow control” on
page 147
set mirror-interface
<slot number>/<port number>
“Configuring mirror ports for PBR traffic” on
page 152
show monitor actual “Displaying mirror and monitor port configuration” on
page 153
show monitor config “Displaying mirror and monitor port configuration” on
page 153
speed-duplex
<value> “Speed/Duplex negotiation” on page 144